RE: Door 3rd pin (was: Roll Trim Tab)

[John Cliff <john@crixbinfield.freeserve.co.uk>]

An aggregation of 3 messages from the bounce bin.  Sender was
"Chuck Popenoe" <chuckp@smartbolts.com>

*********************************************************

Hi Rog-

Am I missing something?  Does this take the place of the 3rd pin?
Could you elaborate?

Pops


What is Graham's mod?  Have not been informed.

Pops


I'm slow, but I think I'm getting it--the ball is nothing more than a
low aspect ratio pin.  It sounds like not a bad idea!  I think that I
would use a smaller diameter steel ball, however.  Am I off base?

Pops