Since any "third pin" bushing would be located outboard of the weatherstrip
seal, how is water kept out of the cockpit?
Best regards,
Rob Housman
A070
-----Original Message-----
Behalf Of Graham Singleton
Subject: Re: Door latch push rods
>I don't think you could offset the problem by the position of the
"receiving
>bush" unless the parallel part of the bolt is well exposed from the door.
>Regards
>Bob Harrison G-PTAG
The "receiving bushes" have a secondary advantage, they restrict the fore
and aft movement of the door in the frame.
If you have the Jonti Docker door mod, a half round peg that sits in a
recess in the lower door frame and restricts the door from bulging outwards
with cockpit over pressure, (when the ventilator is wide open) there's
almost no way of latching the doors incorrectly, easy with standard door
fit. Similar;y with Bob Jacobson's third pin.
Fit the extra bushes, they also stop the glass fiber edges wearing the
aluminum pins out quickly.
Graham
|