europa-list
[Top] [All Lists]

Re: Europa-List: Sticking throttle cable, need a good fix!

Subject: Re: Europa-List: Sticking throttle cable, need a good fix!
From: JEFF ROBERTS <jeff@rmmm.net>
Date: Mon, 15 Jun 2009 10:45:00

Also Bob check your carb springs. I had one once that was a little  
lazy. New spring fixed it. Just a thought.

Jeff R.
A258 - N128LJ / Gold Rush 186 hours and climbing slowly.


On Jun 15, 2009, at 10:21 AM, Jeff B wrote:

>
> Bob,
>
> Solids would do the trick.  I used them when I was researching the  
> problems I was having earlier.  However, you might want to research  
> the reason for the binding.  Make sure the cable enters the housing  
> straight on and exits the same.  Make sure the pivots on the throttle  
> arm are free from binding.  No tight bends, anywhere in the run.   
> Flushing the housing and relubricating the whole thing may help.
>
> As for the solids vs braided, I've seen no real difference, other than  
> to help with a binding problem.  On a properly run set of cables, the  
> originals work fine...
>
> Jeff - Baby Blue
>
> Robert Borger wrote:
>> Fellow Europaphiles,
>> I need a recommendation for my sticking throttle problem.  I thought  
>> I had it fixed, but I flew this morning and it happened again.  Flew  
>> from Denton (KDTO) to Ironhead (T58) for landing practice.  First  
>> landing was excellent.  Taxied back for takeoff, applied full  
>> throttle and started to roll.  RPM only went to 4000.  Aborted the  
>> takeoff.  Taxied back to takeoff, held the brake, worked the throttle  
>> and was rewarded with 5780 RPM.  Released the brake and took off,  
>> flew back to KDTO, landed (OK landing, bounce, power, stabilize, land  
>> right).  Went back to the hanger and pulled the upper cowl.  The port  
>> throttle cable was hanging up again.  I have posted pics on my build  
>> web site.  Starboard throttle goes to full, port only goes half way.   
>> By working the throttle one can get full throttle on both, but that's  
>> not right.  I need a good fix for this problem.  I have heard about  
>> teflon liners and solid cables.  I'd like some feedback on what folks  
>> have found to really work and how the installation was done.
>> Thanks in advance,
>> Bob Borger
>> Europa Kit #A221 N914XL, XS Mono, Intercooled 914, Airmaster C/S
>> http://www.europaowners.org/N914XL
>> Aircraft Flying!
>> 3705 Lynchburg Dr.
>> Corinth, TX  76208
>> Home:  940-497-2123
>> Cel:  817-992-1117
>> ---------------------------------------------------------------------- 
>> --
>> Checked by AVG - www.avg.com
>
>



<Prev in Thread] Current Thread [Next in Thread>