Vaughn,
If your cockpit module is properly installed, the top of the tank
compartment should be level. I leveled the lower fuse, at that point
and then used a level on the torque tube to set it. I found that the
sides of the fuse, at the rear were a bit out, when checking against the
front. Once the bearings are bonded into place, they will stay, without
a problem. Be sure to spread the two sides of the fuse, to match the
proper width, before setting the bearings...
Jeff - Baby Blue
231 hours
Europa List wrote:
> One other issue. The starboard end of the elevator torque tube needs
> to be raised abou 1/4" in order to make it level with the fuselage
> sides. I'm assuming that if I I bond the top on with it raised to
> level. It will stay level after all has cured. Am I correct?
>
> Vaughn Teegarden
>
> N914VA
> Does anyone know where I can obtain a reasonably priced 914?
>
>
>------------------------------------------------------------------------
>
>
>
|