On 2016-12-17, at 21:13, Roland <schmidtroland@web.de> wrote:
> One more question: last time when we installed the rubber mounts, we managed
to compress not only the MT04's but also the MT03 steel-spacers with which to
me seemed like a reasonable torque, so that I also had to order new MT03's from
Europa.
>
> Although the MT04 should be fully compressed on the MT03 spacers I'd like to
avoid to again damage the MT03's by overtorquing for obvious reasons.
>
> Any suggestions as to how to make it right? The installation manual only
> states
"tightened fully:
Roland - I fitted the rubber mounts not very long ago. Although some effort was
required to compress the rubbers, I found that it was relatively easy to feel
when the MT02 cup washers came into contact with both ends of the MT03 spacers
- there was a distinctly more solid resistance to further tightening.
in friendship
Rowland
| Rowland Carson ... that's Rowland with a 'w' ...
| <rowlandcarson@gmail.com> http://www.rowlandcarson.org.uk
| Skype, Twitter: rowland_carson Facebook: Rowland Carson
|