Hi Bob,
I know what an "I" section is, but I just can't imagine what you mean. If you
said
"L" shape, to protect the Trailing edge of the rudder pedal attachment shelf,
I would have been with you, but I'm a tad lost.
Tony R
Sent from my iPad
> On 3 Mar 2014, at 11:09 pm, "Bob Harrison" <ptag.dev@talktalk.net> wrote:
>
>
> IMHO Bad idea . I just put a piece of 1.5" "I" section aluminium across the
> footwell step and it works for me and I'm 5'9" and on a long flight you will
> need to practice "walking" with as much room as you can have to prevent the
> onset of cramp in the legs.
> Also keep your knee from being near the draught vent more cause for cramp!
> After a 4hour 30 minute flight to Krems Vienna My choice was to pretend
> walking like hell or choose landing along or across vineyard wires on fields
> as for as the eye could see, with tears streaming down my face. Also dose up
> on a good layer of Quinine tablets !
> Regards
> Bob H G-PTAG
>
> -----Original Message-----
> From: owner-europa-list-server@matronics.com
> [mailto:owner-europa-list-server@matronics.com] On Behalf Of Tony Renshaw
> Sent: 03 March 2014 11:40
> To: craig; europa-list@matronics.com
> Subject: Re: Europa-List: Rudder Pedal Step Stretching
>
> --> <tonyrenshaw268@gmail.com>
>
> Hi Craig and co.
> I want to put 75 mm onto the shelf, bringing it aft into the footwell, to
> give me a place for my heels. Is that a dumb idea because only being 5' 9"
> or 175 cm, I think my legs will easily fit, and I imagine because of the
> upright nature of the pedals at neutral, that it might be nice to build a
> heel support. Bad idea???
>
> TR
>
>> On 3 Mar 2014, at 10:00 pm, craig <craigb@onthenet.com.au> wrote:
>>
>> Yes tony, you can take about 75mm off, I worked out where the mounts
>> were going to be then cut it back To leave about 15mm past the end of
>> the rearmost mounts
>>
>> -----Original Message-----
>> From: owner-europa-list-server@matronics.com
>> [mailto:owner-europa-list-server@matronics.com] On Behalf Of Tony
>> Renshaw
>> Sent: Monday, March 03, 2014 12:30 PM
>> To: europa-list@matronics.com
>> Subject: Europa-List: Rudder Pedal Step Stretching
>>
>> --> <tonyrenshaw268@gmail.com>
>>
>> Gidday,
>> I've heard it mentioned that to extend this step back a bit might make
>> things more comfortable. Can I get an input on what dimension is
>> recommended? I've heard about 75 mm would do it, and I will probably
>> build it into my floor mat mod that I want to do.
>> Thanks.
>> Regards
>> Tony Renshaw
>> Sydney Aussie
>>
>>
>>
>>
>>
>>
>>
>>
>>
>> -----
>> No virus found in this message.
>> Checked by AVG - www.avg.com
>
>
>
>
>
>
>
>
>
>
|