Andrew,
Try heating the spar socket to allow the spar to be released. You may have t
o redo the setting.
Cheers,
Tim
Tim Ward
12 Waiwetu Street
Fendalton,
Christchurch, 8052
New Zealand.
ward.t@xtra.co.nz
Ph 64 3 3515166
Mob 0210640221
> On 23/09/2013, at 6:54 am, Andrew Sarangan <asarangan@gmail.com> wrote:
>
> I am hoping someone will have a great idea to solve this problem. I just f
inished gluing the spar sockets, but I am unable to withdraw the port spar o
ut of the starboard socket. I was able to get the bolts out quite easily. It
also doesn't look like the spar got glued to anything, because I am able to
rotate the spar, and wiggle it just but it won't slide out of the socket. W
hat I suspect is that some flox might have oozed into the inside face of the
socket which and might be preventing the bushing from sliding out. I grease
d everything, but did not grease the inside faces of the sockets. If all fa
ils I was going to cut the outer face of the socket to extract the spar. Per
haps I could reglue that face back in place. Any ideas would be appreciated.
>
>
>
>
>
>
3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3
D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D
=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D
3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3
D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D
=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D
3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3
D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D
=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D
3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3
D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D
=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D
>
|