Hi. Richard.
That looks a good fix to me, pulling up on both side of the tube, i can,t see
that
moving anywhere.
Next project is to get rid of the pins on the TB12 drive plate,
Make a drive plate with all the external edges angled at 90 degrees ,ie a male
drive plate, and a mirrored female drive plate fitted to the stabilator, all
of this female drive plate slides up into the male drive plate, all the surfaces
making a tight contacting join.,and full transmission load spread over the
entire surface,
No little pins and no lugs, so no chance of miss alignment damaging or pin wear
or breaking .
All of this would last the life of the aircraft
Alan
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=385675#385675
|