H! Carl
Yes that is the pin but mine is an Avdel Pin with the expanding balls to
retain it in place. So I guess you are OK but it for sure would be very
difficult rigging on your own , for my money I would do as Neville has
recommended soonest.
Regards
Bob Harrison. G-PTAG
From: owner-europa-list-server@matronics.com
[mailto:owner-europa-list-server@matronics.com] On Behalf Of Carl Meek
Sent: 24 November 2011 20:49
Subject: Re: Europa-List: Any idea what this is?
Do you mean the main starboard pin that goes behind the seat cushion? My
pin has a double lock on it to totally prevent it coming loose,
presumably this is ok without the part? I recently derigged and rigged
with no real issues, despite part not being in place.
Regards
Carl
Sent from my iPhone
On 24 Nov 2011, at 20:14, "Bob Harrison" <ptag.dev@tiscali.co.uk> wrote:
Hi! Carl
It is the receptacle can for the port spar and should be reduxed to the
rear of the starboard seat back/tank forward bulk head.
It is damaging the ruder cable in the present location. And was probably
knocked off by misdirected assembly.
If it is not in position between both spars it will allow the starboard
pin to be end loose, and therefore IMHO it is a critical part.
I recently advised putting leading ramps on to this item to safly guide
the port spar into the can rather than thumping it off.
It also occurres to me to say that one of your fuel pipes isn=99t
pushed right home under the clip?
Regards
Bob Harrison.
From: owner-europa-list-server@matronics.com
[mailto:owner-europa-list-server@matronics.com] On Behalf Of Carl Meek
Sent: 24 November 2011 12:56
Subject: Europa-List: Any idea what this is?
My engineer just found this floating around in the belly of the
aircraft, he was quite worried it could get entangled somewhere and jam
a control.
The question is. What is it? Did it do something important?
Thanks,
-Carl.
<image001.png>
<image002.png>
|