europa-list
[Top] [All Lists]

Europa-List: Tail wheel stops on the monowheel

Subject: Europa-List: Tail wheel stops on the monowheel
From: Bud Yerly <budyerly@msn.com>
Date: Sun, 12 Jun 2011 20:40:46
Gentlemen,
Two recent ground loops have occurred to proficient pilots.
In both cases the tail wheel had no stop installed or it had failed 
previously during ground operations and was not repaired.  In the course 
of the landing and rollout, during a bounce and heading excursion the 
tail wheel went well beyond 45 degrees of course and control was lost on 
landing rollout which resulted in an outrigger grabbing and during the 
ground loop the tips of the prop were damaged when tail rise occurred.

One pilot insisted the tail wheel actually spun forward at low speed.  
Some older incidents indicate thatd without the limiter, other low speed 
ground loops have occurred as the tail wheel control was lost.  Europa 
has always maintained that the limiter was necessary.  Some have 
insisted that a limiter was not necessary and or a swivel tail wheel was 
preferred.  Ground handling incidents indicate that the safer course is 
to install the limiter as described in the manual.

Bottom line:

The mono needs a limiter on the tail wheel to preclude loss of control.  
 Either the Europa supplied spring pin limiter or a Graham Singleton 
stop should be used.

Taxi, landing, and takeoff without the limiter may cause loss of 
control.  

To prevent tail wheel limiter damage, the aircraft should not be pushed 
backwards as the tail wheel hollow shaft will contact the spring pin and 
eventually the spring pin can be damaged and fail.  Without a spring pin 
limiter, the tail wheel can be flipped around and cause the tail wheel 
springs to be stretched and fail especially when pushing the aircraft 
backwards.  Use a proper tail wheel trolley to pull the aircraft 
backwards.

On a similar note:
Should the tail wheel spring arm be installed about 2 inches higher than 
the manual described, the tail wheel geometry will actually drive the 
rudder and flick the tail wheel around when passing 60 degrees causing 
the tail wheel to restrict rudder movement and a loss of control will 
occur.  

I have voiced my opinion on the spring pin used in the tail wheel was 
not as robust as I would like and should be inspected annually, but the 
Graham Singleton V block works great and is pretty much full proof.  
Either way, please install the limiter, as without it, it is just a 
matter of time before a potential loss of control may occur during 
ground operations.

Regards,
Bud Yerly
Europa Tech Support


<Prev in Thread] Current Thread [Next in Thread>