William
yes it is correct, BUT, they need to be the same at two thirds span, ie
roughly where the flap ends. Any difference here or further out will
cause a roll bias.
So, check the second wing at the tip of the flap against the incidence
of the first wing at the same point. Now if there is any difference in
twist of the wings it won't matter so much.
Graham
William Daniell wrote:
>
> I have set my wing incidence using my trusty digital level.
>
> I did one first which I walked away from at 2.5deg and when I came back it
> was 2.4deg. so I set the other one the same. Does anyone see a problem
> with this? I seem to recall an earlier thread in which they key issue
> seemed to be getting both wings the same.
>
> Is this correct?
>
> Thanks
>
> Will
>
> Checked by AVG.
|