europa-list
[Top] [All Lists]

RE: Europa-List: Anyone install battery aft of baggage bay bulkhead?

Subject: RE: Europa-List: Anyone install battery aft of baggage bay bulkhead?
From: Simon Smith <jodel@nildram.co.uk>
Date: Thu, 21 Sep 2006 20:27:06

Mine is under the baggage bay so can't really comment on that.

What I can say is that wrapping the exhausts is a big no-no. It causes them
to crack.  It was mentioned in a factory newsletter quite a while back.

Secondly, the purpose of the mass balance arm is to balance the Stab'. If
Mod 70 is heavier them surely it will be out of balance???

Simon

-----Original Message-----
From: owner-europa-list-server@matronics.com
[mailto:owner-europa-list-server@matronics.com] On Behalf Of
rparigor@suffolk.lib.ny.us
Sent: 21 September 2006 19:57
Subject: Europa-List: Anyone install battery aft of baggage bay bulkhead?


Anyone install battery aft of baggage bay bulkhead? Do you find access
through D panel a real pain? What battery, what size wire did you run, was
starter performance acceptable?

Any pictures?

Any opinion if I should make choice to mount battery there now or wait
till build is complete?

I suspect my XS Monowheel will tend to be on the nose heavy side. 

914
HD Starter
Intercooler
Oil Thermostat
Exhaust wrapped
CS Airmaster
Cooling air baffle
B+C ND Alternator
Full interior
Panel that is pretty full
Structural up stop, 3/4" marine ply and glassed to tunnel (both sides)
aluminium just forward of tyre 
Probably inflight adjustable cowl flaps and landing light in cowl

First fly with short wings, then will build glider wings (more nose heavy)

Tail heavy stuff
Have extended range fuel tank that will be used intermittent 
2 Andair 375 Gasculators aft of Baggage bay ribs in a box and cover/latch
Tank water drains just aft of box
Series pumps with bypass valves
Mod 70 which is heavier, also 2 turnbuckles, cables and butterfly
Rudder cable turnbuckles
Repaired stabilators (inner and outer bushings) stuck from bottom, (extra
glass and flox)
Stabilator drive bushing repair (redux/flox/washer)
T-Bar guide, balsa and 2 BID
Glassed foam support to maintain width dimension above mass balance arm 
2nd antenna and wiring
ELT
Kunzleman strobe box and LED position/Strobe on wingtips
Roll servo and associated
TE Probe and associated on rudder



<Prev in Thread] Current Thread [Next in Thread>