In a message dated 1/14/2005 1:15:37 PM Pacific Standard Time,
asarangan@YAHOO.COM writes:
You can draw rivets directly through thin metal without
prepunching a hole. Thin metal slugs drop out of the outlet hole on the
side of the tool.
USE AS DESCRIBED IN THE FULL TEXT EXEPT IGNORE (You can draw rivets directly
through thin metal without
prepunching a hole. Thin metal slugs drop out of the outlet hole on the
side of the tool.), AS THIS IS NOT SUITABLE.ONCE YOU SEE THE TOOL ITS USE IS
OBVIOUS.
SAM N77EU
|