My flap measurements on the foam wings of UK Classic Kit 327 are:-
Port 203mm at root end and 83mm at the tip end.
Stbd 202mm and 83mm,
But I am adding a bid trailing edge extension of 10mm to the Stbd root end
to align with the flap.
JR (Bob) Gowing, 24 High St, BEGA NSW 2550
----- Original Message -----
From: "stevecharron" <stevecharron@my-bits-and-pcs.com>
Subject: Re: Flange to trailing edge measurements.
>
> I had pre skinned ailerons with the same discrepancy . My resolution to
> this problem was to install a bid extention to the aileron , install the
> aieron onto the wing , run string from wing tip trailing edge to flap
> trailing edge and trim down to the string - leaving a bit extra meet to
> work with.
> Steve c a190 www.goflyin.com/europa
> KarkelB@aol.com wrote:
>
> > From: KarkelB@aol.com
> > Date: Thu, 4 Apr 2002 14:30:13 EST
> > Subject: Re: Flange to trailing edge measurements.
> >
> > Hi Folks,
> > just completed my ailerons and measured the distance from
the
> > flange to the trailing edge on either side of each aileron. Found on
> > the port
> > aileron the difference was 1cm and on the starboard aileron the
difference
> > was 2cm. I suspect an error when the foam was being hot wired.
> > Can someone please measure the distance of a completed aileron from the
> > flange to the trailing edge and let me know what the measurements are.
> > Preferably if its already fitted to the wing( XS WINGS) .
> >
> > regards Karim.
>
|