No, tg is in the lower hundreds from a room temp cure typically. Post curing
typically
raises it some 10s of degrees. So its not mandatory, but does help somewhat
in hot climates.
Best to reference the epoxy spec sheets for specifics.
Cheers,
Pete
> On May 28, 2020, at 5:30 PM, flyingphil2 <philipjtiller@gmail.com> wrote:
>
>
> Ah!
> So does it mean that the 'Tg' is essentially room temperature unless you post
cure it and raise it to a higher figure?
>
> Does that also mean that unused control surfaces that are 19 years old should
still be post cured then?
>
> How many builders did this? There's no mention of post curing in the build
> handbook
is there?
>
> Thanks,
> Phil
>
>
>
>
> Read this topic online here:
>
> http://forums.matronics.com/viewtopic.php?p=496553#496553
>
>
>
>
>
>
>
>
>
|