Hi All.
MGL. Instructions. It is highly recommended a small jet is installed on engines
with low fuel flows.
The sender is delivered with a small jet that can be installed in the flow
senders
inlet, Installation of this jet is recommended with engine with fuel flows
less than 30 gal/Hr, this would apply to most small 2 stroke and 4 stroke
engines.
The FF-1 is shipped with the fuel flow sender calibration set for the jet
installation,
in a good installation you can expect an accuracy of +- 3% you can calibrate
the sender yourself to a higher degree of accuracy if you desire.
So it the FF-1 , mentioned here, so what about other makes of senders,
does this only apply to the FF-1 ?????
Alan
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=408495#408495
|