Hello All.
Sorry but I may have got into a bit of a muddle over this.
1. At LAA Show Rotax Stand, said the flow rate being pumped around the system on
a 914 was about 100 Ltr/Hr.and my sender could cope with measuring up to 136
an hour.
Does not fit in with what the Forum are saying, but maybe the bods on the Rotax
Stand have it wrong.
2. On Advice from the Rotax Stand, and the MGL Stand, I purchased the
Flowscan "A" model 0 to 30 gallons and hour, ("B" modal was 0 to 60 Gph) for
larger
engines.
3. The MGL instructions referring to installing these in line Jets before the
sender, which it clearly states, but give no information on,
I believe may be only relating too, and with installing a MGL Flow Sender,!!
However I think the whole lot is very poor with the instruction, and what Sender
to use.
Rotax Stand, Rotax don,t approve of any Flow sender being install in the fuel
line,
Regards .
Alan
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=408490#408490
|