Hi Howard,
You may have some success if you contact Nigel Charles. He will at the
least know where to source the required materials. You will find his
address and details in the Europa Flyer. His club e mail address is
mods@europaclub.org.uk
Regards
Pete
-----Original Message-----
From: owner-europa-list-server@matronics.com
[mailto:owner-europa-list-server@matronics.com] On Behalf Of scudrunner
Sent: 08 November 2006 16:34
Subject: Europa-List: Europa Club Outrigger Pivot Bearing Mod
<howard.brooks@nomura-asset.co.uk>
I'm looking to source the materials to do the above modification. Before
going searching the net for steel tubing suppliers, I though it would be
worth asking the (UK members of the) forum if anyone could either recommend
a supplier, or sell me the offcuts left over from when they did the mod?
Basically I need a short length of 3/8 inch stainless steel tube and a short
length of 5/16 inch steel tube (the steel tube needs to be a good fit in the
stainless one). Oh, and some nylon spacers/washers. I guess 6 inches of
tubing would be ample.
Any advice from those who have gone before?
Thanks
Howard
Visit - www.EuropaOwners.org
--
--
No virus found in this outgoing message.
|