<CF5EEA66AA042B4C819BFB583EB88EE49D8B3B@FR0-MAILMB21.res.airbus.corp>
Many thanks, Patrick, for your comment.
Would defenitively appreciate some photos to imagine this installation.
Any effect you expect or experienced already with cutting a hole into the air
shroud?
Or isn't there such shroud on the 914 at all?
Regards
Michael
-----Original Message-----
From: owner-europa-list-server@matronics.com
[mailto:owner-europa-list-server@matronics.com]On Behalf Of
BEBERRY@aol.com
Subject: Re: Europa-List: Arplast Prop.PV50
Michael - I have just fitted a PV50 to a 914 and I think there is very
little difference. The control unit fits onto the two bolt holes on top of the
engine block and I found it necessary to raise the coolant filler and extend
one of the hoses. I then made a protective aluminium shield to bolt over the
top of the controller so that the coolant filler sits on this. It has a rubber
pad on the lower side, presumably for this very purpose.
When I next go to my aircraft I will take a photo to send to you.
Good luck Patrick
This mail has originated outside your organization,
either from an external partner or the Global Internet.
Keep this in mind if you answer this message.
This e-mail is intended only for the above addressee. It may contain
privileged information. If you are not the addressee you must not copy,
distribute, disclose or use any of the information in it. If you have
received it in error please delete it and immediately notify the sender.
Security Notice: all e-mail, sent to or from this address, may be
accessed by someone other than the recipient, for system management and
security reasons. This access is controlled under Regulation of
Investigatory Powers Act 2000, Lawful Business Practises.
|