Brian,
After I hit send I realized I didn't answer the second part of your
question.
The TP9 should be moved out of the way of the template or not even installed
on the torque tube while you are doing the alignment.
John
----- Original Message -----
From: <EuropaXSA276@aol.com>
Subject: Re: Europa-List: TST template and Trim Bellcrank.
>
> In a message dated 1/26/2005 3:26:20 PM Central Standard Time,
> eckel1@comcast.net writes:
> My torque tube measures 1.5 inches in Dia, the same as the template.
> The template rests directly on the torque tube, see Fig. 5.
>
> Suggestion--when mounting the TS01 and TS02 brackets use anchor nuts.
> The same for the MAC trim servo. It will make removal and installation
> of these parts so much easier if the need arises. (Ron Parigoris idea)
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>
> Good idea on those nutz John. As much as I do not what to think about
> it...
> That servo will have to be replaced at some point. What kind of anchor
> nuts
> did you use?
>
> Back on this template. Did you use the template with the TP9 installed on
> the tube?
> The bolt will just barley touch with the trim assembly on center line and
> the
> template on the tube and edge on the TP9. I can lean the template over for
> good contact but that lowers the bracket!
>
> Having one of those days....
>
> Brian Skelly
> Texas
> Europa # A276 TriGear
> See My build photos at:
> http://www.europaowners.org/BrianS
>
>
>
|