Do Not Arcive
Helo Jim Nelson
All sounds very reasonable.
What do you think about including on your description, a piece of chain that
lays on the ground? Some say that they thought a piece of Stainless Steel
Toilet Plunger chain would be a good addition?
Thanks
Ron Parigoris
James Nelson wrote:
>
> Ron,
> Try to refuel with metal cans rather than plastic. (Tough to
> find) I bonded my whole system to a common point that extends with a
> metal tab below the fuselage next to the fuel drains. This way I can
> hook up a grounding strap and the whole fuel system is ground potential.
> My fuel entrance fitting that the cap goes into is grounded to the
> outlets at the tank and to the ground in the electrical system. You can
> ground the fuel system in the bottom of the tank by using the aluminum
> fittings that provide sump drains. The redux will provide an electrical
> pathway so the copper lines that go deep into the tank can pull static
> out. Use a small screw clamp to hold a wire onto the fitting on each
> side. These should go to a common point for bonding. I also put in a
> braided cable from the entrance down through the plastic tubing into the
> tank all hooked together at one point. Ta Da. !! I think its the best
> you can do with our plastic airplane.
>
> Jim Nelson
> N15JN
>
|