Dear Steve,
The rib to aileron close-out is not connected to avoid distorting the close-out
top and bottom flanges, which would make fitting the ailerons difficult.
Although this is not covered in the build manual, you should join the rib to the
aileron close-out with a 2" 'bid' tape immediately before bonding on the tp
skin after fitting the aileron and clamping it in neutral as descibed at page
9-20.
This will be added to the build manuals at the next update.
Kind regards
Technical Department
>>> "Steven Pitt" <Steven.Pitt@btinternet.com> 07/04/01 11:18pm >>>
I too have noticed that the ribs are not connected at the aileron section. If
anyone
has an answer to why or what to do about it then thanks.
Steve Pitt #403 XS wings
|