-- MIME Errors - No Plain-Text Section Found -- A message with no text/plain MIME section was received. The entire body of the message was removed. Please resend the email using Plain Text formatting
Someone on the WatsApp group were offering to do just that. I suggest a message on that group might get a response or even a link to a printing company that will do them. You could always whittle dow
I am a Europa Club Member and have just downloaded the STL files at no cost from the club website so I dont understand your comment; which I feel is a bit "off". << Alan Sent from my iPad again. The
I have 5-6cm square hinged flaps cut into the sides of the fairings, secured with a single screw into a captive nut. There is just enough room to get you fingers through the hole after you rotate the
I wonder if its worth adding an item to 6mon/50Hr/ Annual to reverse blow the vents to clear any crud collected? Alan. Sent from my iPhone will put 2 plastic filters and include a verification during
I have made pitot and fuel vent covers from clear plastic tube. The tube is bent double and slips over the fuel vents and also Pitot:static and has the red remove before flight tags attached. Alan Se
G-IANI is indeed still flying, I know the owner is on the WhatsApp group but not sure about this one. I had that mod installed on mine, G-OBJT but could not see any benefit and blocking it off decre
Because you may find that the air pressure behind the D panel is higher than the cockpit and so you will simple see air coming from the rear to the cockpit unless you have some arrangement in the ta
Dont forget that you have the slots for the flaps which are below the wing during normal flight and may influence the pressure in the rear that you will need to compensate for. Alan Sent from my iPad
I have four u bolts at each corner of the baggage bay. They are bolted to hard points made by floxing a ply layer under the bay floor.. You can get a cargo net from any motorcycle dealer as the are