John, I am so sorry to hear of your accident. Even more so when the
accident was due to a mechanical malfunction or a design flaw. If it's any
consoliation, I had almost the same thing happen to me at about 18 months
and 80 hours of flying. On preflight engine run-up to 4000 rpm for a mag
check, everything seemed normal. However when I gave it full throttle for
take off, I couldn't get much more than 4500 rpm and my seat-of-the-pants
told me I wasn't getting the acceleration I was used to. I debated for a
second or two, but then aborted the takeoff. Upon further inspection I
found that only one of the throttle cables had kinked as you described.
The other cable was working normally. The kinked cable had to be replaced.
Like you, I think the design is faulty and prone to malfunctioning. At
some point in time, everyone is going to experience this problem as the
cables will accumulate rust, dirt, etc. If someone comes up with a fix,
please post it asap. Again John, I am so sorry for the damage to your
plane. Thank goodness you weren't hurt any worse than you were.
Regards,
Garry
N4220S
(813) 878-3929
FAX (813) 878-5651, Internet ID Garrys@att.com
|