europa-list
[Top] [All Lists]

RE: Europa-List: 914 Servo Problem -- broken copper wiper -- is there

Subject: RE: Europa-List: 914 Servo Problem -- broken copper wiper -- is there
From: Bud Yerly <budyerly@msn.com>
Date: Sun, 21 Mar 2021 00:32:13

Paul,
No, not this specifically.
I had a wiper wear through and begin to hesitate.  $500 and I was flying again.
Check ebay as there are usually a few on there.  Typically about $150-$250 and
good for parts or sometimes good for a replacement.  But check the part number.
The Skido Rotax 914 marine engine used the same servo but you don't normally see
these for sale.

Best Regards,
Bud Yerly

-----Original Message-----
From: owner-europa-list-server@matronics.com 
<owner-europa-list-server@matronics.com>
On Behalf Of PCahill
Sent: Saturday, March 20, 2021 7:01 PM
Subject: Europa-List: 914 Servo Problem -- broken copper wiper -- is there a 
fix?


The picture shows the inside of my TCU wastegate servo where the tip of one 
wiper
has broken off and is now stuck against (perhaps with dielectric grease) what
appears to be a screen printed resistor that is used by the TCU to measure
servo position. 

The symptom was a jammed wastegate cable and a blinking orange TCU light that 
appears
about 6 seconds after power up (not immediately like what happens with
a disconnected sensor).  After I removed the jammed cable from the servo wheel,
the servo rotates "too far" on power-up -- clockwise past the cable mount before
returning to the start position.  No wonder the servo and cable were jammed.
When I opened the servo, the broken copper wiper was obvious.

Has anyone else seen this?  Can I buy a gear with the copper wipers, or maybe 
just
the wipers themselves?  This happened suddenly: 2 weekends ago everything
was perfect, last weekend -- blinking light.  This weekend -- disassemble until
problem found.  I can't imagine that I'm the only one with what amounts to a
potentiometer with a bad wiper.  This is certainly not a $500 failure (cost of
new servo).  Thanks.

--------
N914TX


Read this topic online here:

https://na01.safelinks.protection.outlook.com/?url=http%3A%2F%2Fforums.matronics.com%2Fviewtopic.php%3Fp%3D501039%23501039&amp;data=04%7C01%7C%7C5a2c8240a607403949f908d8ebf490d1%7C84df9e7fe9f640afb435aaaaaaaaaaaa%7C1%7C0%7C637518782921486301%7CUnknown%7CTWFpbGZsb3d8eyJWIjoiMC4wLjAwMDAiLCJQIjoiV2luMzIiLCJBTiI6Ik1haWwiLCJXVCI6Mn0%3D%7C1000&amp;sdata=RM9KDDwHLeDz9bFueo%2FU7%2FF8t%2FRMirZWp8TRbzGmQWY%3D&amp;reserved=0



<Prev in Thread] Current Thread [Next in Thread>