I think so, but it was a while ago. I think I set it up with the angles shown
and
then checked that there was sufficient movement full forward and back, and
that there was no danger of 'over centre', the real no no. And yes, you wouldn't
want to do this mod too many times!
Roddy.
-----Original Message-----
From: david park <dpark748@icloud.com>
Sent: Wed, 25 Nov 2015 9:50
Subject: Re: Europa-List: Re: Altitude Hold kit. Trio.
Just to be certain, i only want to do this once!!!!
Did you translate the angle from the drawings on Mod 76.
Dave
Sent from my iPhone
On 25 Nov 2015, at 09:28, roddyeuropa@aol.com wrote:
I did this mod a couple of years back and used the original CS10 torque tube,
and
had the europa supplied lugs welded on by a local specialist aircraft welder.
I preferred to keep the original control system as much the same as possible.
Getting the lugs welded on was not the hardest part - its a lot of work to
get the torque tube out, and also very fiddly to connect the new servo rod -
there
is just so little room to work.
In answer to your question "I just want to confirm that the Alt. Hold horn is
exactly
the same orientation as the Stabilator port horn" I'm pretty sure that
the horn is not the same orientation, but the drawings in mod 76 show the
correct
position. The position is vital - I made a jig to hold it in place so there
was no question of the welder putting it in the wrong place. So good luck!
Roddy Kesterton
G-IKRK
-----Original Message-----
From: david park <dpark748@icloud.com>
Sent: Tue, 24 Nov 2015 23:16
Subject: Re: Europa-List: Re: Altitude Hold kit. Trio.
Europa supply a kit to modify the CS10 by welding the two horns onto the CS10 to
take the pushrod from the servo.
Dave
Sent from my iPhone
> On 24 Nov 2015, at 22:12, graeme bird <graeme@gdbmk.co.uk> wrote:
>
>
> Have you replaced cs10 then ? How easy was it?
> It sounds like you are adding horns to the existing.
>
> --------
> Graeme Bird
> G-UMPY
> Mono Classic/XS FFW 912S/Woodcomp 3000/3W
> Newby: 200 hours 4 years on the Mono
> g@gdbmk.co.uk
>
>
>
>
> Read this topic online here:
>
> http://forums.matronics.com/viewtopic.php?p=450192#450192
>
>
>
>
>
>
>
>
>
>
|