Keith
thanks very much
Will
William Daniell
LONGPORT
+57 310 295 0744
On Fri, Apr 3, 2015 at 4:39 AM, Keith Hickling <keithhickling@clear.net.nz>
wrote:
> Will,
> Europa told me that you can=99t give a torque figure for them becau
se it
> depends how hard they grip =93 takes quite a bit of torque just to
turn them
> even before they are tight. Just tighten them up firmly.
>
> Nev (via Bob Borger) said :
>
> "No need for them to be too tight, I just nip them up, then a firm tug on
> a regular spanner [ wrench ], at a guess about 125 lb in, plenty tight
> enough to keep them from fretting, not enough to stretch the threads."
>
> Regards,
> Keith.
> Keith Hickling.
> *From:* William Daniell <wdaniell.longport@gmail.com>
> *Sent:* Friday, April 03, 2015 6:16 AM
> *To:* europa-list@matronics.com
> *Subject:* Europa-List: Binx nuts torque
>
> Does anyone know what the torque on the binx nuts which are used for the
> engine subframe to ring mount is supposed to be?
>
> Many thanks
> Will
>
>
> *
>
===========
tronics.com/Navigator?Europa-List>
===========
===========
om/contribution>
===========
>
> *
>
>
|