Hi Tony
You can look at my Nicos in two pages at below link. They look like yours. My
large
tool like yours came with a gauge, you can adjust crimp size. I am pretty
sure 43.13 would give you dimension. If you are only going with one Nico, leave
some cable sticking out, if two Niocos, then you can capture end with second.
I use Teflon shrink tube, needs lots of heat and expensive, but holds up to
nasty sharp end of cable.
I forget if you are building a mono, check out slick 3 Nico short tailwheel
cable.
I mentioned it before, turnbuckles can get tangled together and shorten up, very
bad because you lose rudder travel. See cause and resolution.
http://www.europaowners.org/main.php?g2_itemId=27732
Ron P.
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=419497#419497
|