europa-list
[Top] [All Lists]

Re: Europa-List: Preheating glass cloth

Subject: Re: Europa-List: Preheating glass cloth
From: Robert Borger <rlborger@mac.com>
Date: Wed, 22 May 2013 17:38:00

Tony,

Forget the microwave.  It won't heat glass cloth.  Microwaves heat the water 
content
of items.  No water content to fiberglass cloth.  At least there better
not be any water in the cloth.

Blue skies & tailwinds,
Bob Borger
Europa XS Tri, Rotax 914, Airmaster C/S Prop.
Little Toot Sport Biplane, Lycoming Thunderbolt AEIO-320 EXP
3705 Lynchburg Dr.
Corinth, TX  76208-5331
Cel: 817-992-1117
rlborger@mac.com

On May 22, 2013, at 5:26 PM, Tony Renshaw <tonyrenshaw268@gmail.com> wrote:


> Hi, I'm laying up here in Sydney in temperatures that have recently turned 
> towards
our winter. I'm using West Systems which already does not wet out the cloth
as well as the SP Systems, and has a shorter pot life, albeit in warmer weather.
I'm preheating the job area, the Lift Pin external reinforcement lay ups,
and mixing the resin and hardener under workshop spotlights that generate a
lot of localised heat. The glass cloth though is cold, and I am wondering about
placing it in foil in the oven to heat it up pre layup. I even thought of 
microwaving
it, when my wife isn't at home. Any thoughts on the wisdom or otherwise
of doing this? I want to make the cold cloth as conducive as possible to
allow ingress of the resin into the individual fibres of a single thread, as I
occasionally have had some small splinter strait ions in these layups that 
appear
to be micro dry areas along certain fibres, but the matrix between them is
fully wetted out. Thanks in anticipation.
Regards
Tony Renshaw



<Prev in Thread] Current Thread [Next in Thread>