On 02/21/2011 03:44 PM, Bob Harrison wrote:
> I get this problem. The very thin tufnol packing on the quick connect
> surfaces unfortunately won't take a double layer.
Ah, good to know.
> I stripped off the
> original material mixed up some very thick redux and left both mating
> surfaces quite "proud" of finished thickness(using new tufnol) then fitted
> and pinned the wings into place allowing the redux to cure,
Ok, but during rigging it is I think quite impossible to line up the
stick and the aileron so they mate evenly and don't push away the redux
before the rigging is completed. I usually see the stick moving quite a
bit during rigging. How do you solve this problem? Or is it not a
problem at all?
Thanks,
Frans
|