Even my fingers are getting confused with too many colors:
60 minute hardener (yellow/brown)
30 minute hardener (red)
Q-cel
Expancel
Aeropoxy light
JB weld KWIK
Gray gelcoat
White gelcoat
Fiberglass
Anyway I was thinking about trying out some flat black spray guide coat
purchased
---From Eastwood.
Question is after you apply it and sand most of it off, the black will be left
behind to show low spots, do I need to sand off black in low spots and fill, or
can I fill over black painted spot? perhaps scuff sand with scotchbright?
Thx.
Ron Parigoris
Visit - www.EuropaOwners.org
|