I'm in the process of making the fuel vent pipes. I have two pieces of
stainless
steel tubing, each 150mm long. I need to bend them through 90deg, drill 2
holes in the back and bond them into the fuselage. The manual has no dimensions
for this and I guess it's not too critical but what have other people done?
Dimensions I'm looking for would be:
1. Length from vent forward tip to start of bend.
2. Approx radius of bend.
3. Height of horizontal vent tube above the fuselage skin
4. How much tubing ends up protruding through the lower skin?
Rough dimensions would be great if anyone has a few minutes to spare.
Thanks,
Phil
Visit - www.EuropaOwners.org
|