On Sunday, September 16, 2007, at 09:14 PM, G&TPowell wrote:
> <georgepowell@hotmail.com>
> The torque tube TP4 is extremely tight when I try to put the
> tailplanes on, and it is nearly impossible to get the TP4 to seat
> properly in the TP6 sleeve already bonded into the tailplanes (the
> TP12 pins will not seat into the TP13 bushes, due to the difficulty in
> getting the torque tube in).
George,
I had the same extremely tight fit and found that a liberal coating of
vaseline on the tube did wonders.
Fred
A193
--
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.
|