europa-list
[Top] [All Lists]

RE: Europa-List: Down for the count - fuel tank leak

Subject: RE: Europa-List: Down for the count - fuel tank leak
From: R.C.Harrison <ptag.dev@tiscali.co.uk>
Date: Tue, 14 Aug 2007 12:17:35
He vowed to never have her as a passenger again ! Joke  ..Not intended
that it would be Sue!
D0 not archive.

Robt.C.Harrison

-----Original Message-----
From: owner-europa-list-server@matronics.com
[mailto:owner-europa-list-server@matronics.com] On Behalf Of Pete
Lawless
Sent: 14 August 2007 11:06
Subject: RE: Europa-List: Down for the count - fuel tank leak

Bill

Tell all what did you do to the cow that caused the fuel tank to leak?

Pete


-----Original Message-----
From: owner-europa-list-server@matronics.com
[mailto:owner-europa-list-server@matronics.com] On Behalf Of Bill and
Sue
Sent: 14 August 2007 08:33
Subject: Re: Europa-List: Down for the count - fuel tank leak

 Steve,

I had to replace my tank after an incident with a cow!

It was not as nearly as bad as I thought it would be. ( The repair, not
hitting the cow!)

I removed the tank by cutting the top off the cockpit module about 20mm
below the top edge. The tank was stuck hard to the fibreglass straps
that hold it in place so I just cut it to pieces in place and took it
out bit by bit, this was a bit tedious but did not present any problems.
I prepared the new tank ready so that when I put it in it would be a one
time job only with no in and out trials.
To put the tank in I had to spread the fuselage enough for it to slip in
on to the original support lay-ups and check that it was in the correct
position. When the tank looked to be positioned correctly and not
fouling any controls I then lifted it as high as possible and managed to
get a redux - flox mix on to the brackets sufficient to hold the tank in
place. The top of the cockpit module was replaced using the normal
glass splicing techniques.
I also increased the width of the spacers that prevent the tank from
expanding forward. I was concerned that the amount it moved when full of
fuel could cause cracking.

This all happened 500 hrs ago and it has never shown any defect.

Rgds
Mono XS
914 Airmaster


Bill Sisley


Steve Hagar wrote: 
After having the aircraft down for awhile with the fuel tank drained to
avoid having stale gas present  I noted a leak upon gassing it up. I was
going to bring it over to Phoenix Composites to have the prop
rebalanced.   It looked like it was coming from the lower feed boss
where the big piece of short hose is clamped on.  I was in a hurry and
going on vacation in 2 days for a few weeks. I didn't want to deal with
it then so re-drained the tank to re-address it later.

Upon re-gassing it up upon return the gas started flowing out at a rate
of about a third as fast as I was pouring it in!  Upon inspection it was
determined that it was coming from a crack in the tank near the bottom
of the saddle section reserve side where a fiberglass layup support is
attached.  It appears that the  strapping has acted as a stress raiser
along with expansion and  contraction in the AZ heat.

In any case it looks like it may have to be sawzall time for the top of
the cockpit module for repair.  Has anyone gone through a repair to a
fuel tank an a fully built aircraft?  What was the routine?  I am not
looking forward to this and am possibly considering just parting the
aircraft out.  I could have been out flying and pumped all the fuel out
of  the  reserve return side in a matter of about 10 minutes if I didn't
light it off.

Feed back appreciated

Steve Hagar
A143
Mesa AZ
914
Airmaster


Steve Hagar
hagargs@earthlink.net


__________ NOD32 2458 (20070813) Information __________


-- 
This message has been scanned for viruses and 
dangerous content by  <http://www.mailscanner.info/> MailScanner, and is

believed to be clean. 



<Prev in Thread] Current Thread [Next in Thread>