The instructions do not show what the "Throttle Stops" look like. What
have other 914 users contructed?
Kevin
Mike Parkin wrote:
>
>Craig,
>
>You are in the wrong part of the TLR 43 programme. You need to select
>'monitor', where the throttle position is indicated - 0% to 115%.
>Set up your throttle stops Max, Max Continuous and Idle using this position
>indicator.
>
>regards,
>
>Mike
>
>----- Original Message -----
>From: "Craig Ellison" <craig.ellison2@verizon.net>
>To: <europa-list@matronics.com>
>Subject: Europa-List: 914 throttle stops
>
>
>
>
>><craig.ellison2@verizon.net>
>>
>>All 914 builders and flyers,
>>
>>I attempted to do throttle calibration yesterday and also set the stops
>>for
>>max power(100%) and take-off(115%). The Europa install manual for 914
>>says
>>there are detailed instructions in the Rotax install manual. I couldn;t
>>find any but went ahead anyway. The program page asked for idle and max
>>throttle settings and that was it and said the calibration was complete.
>>My
>>question is how do you set the max contunuous thrattle setting? And is it
>>done with the computer or with RPM and engine running?
>>
>>BTY I did start the engine for the first time. She caught on the first
>>blade and ran very smooth at 1800rpm and above. Carb bal. is next.
>>
>>Thanks for any and all input.
>>
>>craig ellison
>>A205
>>----- Original Message -----
>>From: <NevEyre@aol.com>
>>To: <europa-list@matronics.com>
>>Subject: Re: Europa-List: Close Out Flanges
>>
>>
>>
>>
>>>
>>>Hi Jim and Heather,
>>>Look carefully at the foam cores, they should have been cut, for the
>>>closeout pieces, they may have ''fused'' themselves back on.
>>>Failing that, check with Andy for the length of the cores before you trim
>>>any more off.
>>>Cheers,
>>>Nev.
>>>
>>>
>>>
>>>
>>>
>>
>>
>>
>
>
>
>
|