Folks,
Has anyone out there ever come across any studs that can be bonded to
fibreglass parts? I want to put P-clips on my aluminium fuel lines to hold
them in place, but can=92t find suitable fixings for the clips as I don=92t
always want to put holes through the piece I=92m attaching them to.
I=92m thinking of something like an AN3-3A bolt with an extra large head
intended for bonding.
My alternative, I think, is to make some up out of AN3-3A bolts with the
heads mounted in holes in 3mm ply, and the two ply faces laid up with bid.
Thoughts welcome!
Cheers,
Jeremy
Jeremy Davey
Europa Monowheel 537M G-EZZA
Europa Club Vice-Chairman, Webmaster, PFA NC Representative
PFA EC Member
=93If you can keep your head when all about you are losing theirs, then it is
possible you haven't grasped the severity of the situation.=94
Tail done
Standard XS wings with mods underway
CM installed in fuse (with airbrakes fittings)
1420 build hours to date
Intended fit:
Rotax 914 turbo, Airmaster CS fully-feathering prop
Lots of lights, buttons, switches, gizmos, and alarms
|