Andrew:
I second that advice. (forgot to say that when I replayed earlier)
I aligned the pivot bolt hole with the pivot bolt on the CM by slipping a
short piece of brass tubing over the bolt and sliding it out to locate where
the other bolt should have been. (mine was OK on the starboard side but off
on the port side by an 1/8")
Cliff Shaw
1041 Euclid ave.
Edmonds, WA 98020
425 776 5555
http://www.europaowners.org/WileE
> Hi Andrew:
> I did the same. I only counter bored the hole to the bolt head depth.
> Perhaps a few mm more.
> Warning! Do not flox the hole per the instructions at this time. That
> pivot
> my need some adjustment when setting your wings!
>
>
> Brian Skelly
|