The same 3.3mm drill used for the hinges worked fine
for the rivets. Actually it was difficult to _not_
make a hole below the "V" when you drill through the
hinges. Due to the proximity of the two surfaces of
the "V", once the drill pops out of the flange, it
hits the next surface almost immediately and makes a
hole.
--- Jeremy Davey <europaflyer_3@msn.com> wrote:
> <europaflyer_3@msn.com>
>
> Rowland,
>
> I gotta ask - what's your technique for making the
> holes in the vee BELOW
> the hinge holes bigger than the hinge holes????
>
> In reality 1/8" works just fine - it's just the
> break-head that enters the
> hole in the vee, and that doesn=92t swell in
> diameter. Also it pulls clear of
> the hole very quickly.
>
> Regards,
> Jeremy
>
> Jeremy Davey
>
=====
Andrew Sarangan
http://www.geocities.com/asarangan
__________________________________
http://promotions.yahoo.com/new_mail
|