Jeff,
As I recall I could see the hole through the fiberglass.
If you can't see through because you used peel ply paint
over that area with some epoxy and it should become clear
enough to see through.
John, A230
--- Original Message -----
From: "Rocketman" <topglock@cox.net>
Subject: Europa-List: Wing assembly question
>
> I'm in the process of installing the hardware in the starboard wing, and
> am a little stumped. The manual calls for opening a 1/4" hole, near the
> main pin bushing, closest to the first wing rib, that is suppose to be
> covered over. This hole is to mount the quick connect bellcrank. My
> assumption is that the hole should be above the centerline of the
> bushing and to the rib side. I measured the dimensions, given in the
> manual, and drilled a small pilot hole, hoping to find the factrory
> drilled hole. I didn't find any open hollows, that indicated that there
> was an existing hole. My question is, before I drill the larger hole
> and counter bore, am I drilling in the right place? Thanks for any
> clearification...
>
> --
> Jeff
> Tri-Gear N55XS
>
>
|