Ron:
I had a problem with the tube going into the bushings also, I figured there
was not enough clearance. The problem however was that the toque tube was
not completely round but slightly ovaled, as were some other individuals.
Take a calipers and measure several diameters on the end of the tube to
see if you are getting any variance. There doesn't have to be much. Mark
the high spots and with a gentle hand and a large bench vice squeeze them
down to get a more round configuration. This was a long time ago for me
but I believe I was only out about .008 ~ .010 but it made a real
difference.
Steve Hagar
A143
Mesa, AZ
> [Original Message]
> From: Ronald J. Parigoris <rparigor@suffolk.lib.ny.us>
> To: <europa-list@matronics.com>
> Date: 4/8/03 9:24:55 PM
> Subject: Europa-List: Tailplane issue?
>
<rparigor@suffolk.lib.ny.us>
>
> > Met up with Wayne tonight and took a look for first time at A-265 kit.
> > After a bit of unpacking and looking at manual, descided to see how the
> > torque tube fits into the accelerated tailplanes.
>
> The torque tube had a little oil on it so descided to give it a try after
> cleaning off a bit of resin, and cleaning out pip pin holes..
>
> Left one went on but gets kinda tight when TP12 goes into TP13 bushings.
> Wayne was warned it may be a bit tight.
>
> Tried the right side. Horror. No way is it going to fit. TP4 tube hits the
> edge of the burried TP6. Prior to trying a fitting, i cleaned a bit of
resin
> off of TP5. I looked at the edge of TP4 and it has a chamfer that goes at
> least 1/2 the wall thickness. I light filed the chamfer to make sure, but
> there is a definite alignment problem.
>
> I made sure TP9 was positioned facing down.
>
> This fitting was with the tailplane held by Wayne, and me holding the
Torque
> tube. mostly wiggle very little twisting.
>
> Is it necessary to perhaps gorilla the tailplane onto a secure torque tube
> to fit it?
>
> I think if it were bonded with pieces aligned, the chamfer oin the torque
> tube should be enough to get you into TP6.
>
> I looked through the hole for the Pip pin, and it appears to be lined up
> with TP6.
>
> Any ideas?
>
> I will call John at Europa tomorrow.
>
> If my worst fears come about, and the alignment of TP6 is off, what would
be
> the best way of repairing?
>
> I think a few years ago i read of this happening to someone else, and he
> modified things. Can't remember what was said.
>
> Is this a common problem?
>
> Ron Parigoris
>
> oh yea, our hangar was a little under 40 degrees F
>
>
>
>
>
--- Steve Hagar
--- hagargs@earthlink.net
|