In article <000901c11125$3ee8f080$a2ccfc3e@r68lg>,
paul-d.stewart@virgin.net (Paul Stewart) wrote:
Paul
I had a similar problem.
The hole had been drilled in the rong place and the
pins were replaced by the factory.
Paul Atkinson
> What I now find is that the W26 lift pin socket on
the port side
> 'bottoms
> out' on the aluminium plates bonded into the wing
root (onto which the
> lift
> pin is bonded) before the pip pin holes align. There
is about 1.5mm
> discrepancy. I'm not entirely sure the lift pin hole
has been drilled
> and
> tapped perfectly horizontal. Any one had similar
experience or
> suggestions.
|