Kevin,
I did it both ways and recommend cutting the BID to stop at the balance box
area.
Similarly, don't be afraid to stuff the flox into the gap between the closeout
and the bottom skin, but no need to build in more weight than necessary -
the radius of the mixing stick at the exposed join will be fine for the BID
adhesion.
Going across the balance box area require some cutting away with the Dremel
tool.
Cleve
Mono XS A198
Detroit, MI
On Wed, 18 July 2001, "Kevin Klinefelter" wrote:
>
> Hello All, How about a build question? On the aileron closeout inside the
> wing we are instructed to apply two layers of bid after flox down in the
> little gap between bottom skin and closeout. Except no flox where the mass
> balance boxes go. My question is should the 2 layers of bid go right on
> through the box area? Or will that mess up the fit of the box.
> Thanks, Kevin
>
The ALL NEW CS2000 from CompuServe
Better! Faster! More Powerful!
250 FREE hours! Sign-on Now!
http://www.compuserve.com/trycsrv/cs2000/webmail/
|