RE: Routing cables to the instrument panel

[Bob.Harrison <ptag.dev@ukonline.co.uk>]

Hi! Paul.
I used domestic box section plastic conduit  , the type that has a lid, that
way you can do some "add  too's " later !!!! You can bend it with a heat gun
quite easily  I had two larger ones down the P1 side under the door cill ,
and a smaller section one on the starboard side. Then to route behind the
panel I used lots of the larger spiral  wrap.
Regards
Bob Harrison G-PTAG Kit 337


-----Original Message-----
On Behalf Of Paul McAllister
Sent:        14 January 2001 03:35
Subject:        Routing cables to the instrument panel

Hi All,

I was wondering what folks were doing for cable routing from the back of the
fuselage forward to the instrument panel.  Could some of you share with me
your ideas.

Thanks,  Paul
Builder 363
http://pma.obtero.net