Subject: | Re: Re: Taps [was: Drills] |
---|---|
From: | Europa <Enquiries@europaaviation.co.uk> |
Date: | Mon, 23 Feb 1998 12:16:44 |
Dear all The tap required is 5mm x 0.8 thread pitch. This is used to tap the small tang on the doors to accept the gas strut fixing ball end thingy. Regards Andy > >> what about the 5mm x 1.75. It appears to be a >>non-standard size and what is it used for. Is it correct, the standard size >>I can find is 5mm x 0.8 >Sorry, but I can't guess what the tap might be used for! Factory, do you >need to fit a M8x1.25 fastener into a tapped hole anywhere on the airframe? |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | Filler, etc., JohnJMoran |
---|---|
Next by Date: | Re: SP Resin Batch ID's - What do the numbers, Europa |
Previous by Thread: | Re: Re: Taps [was: Drills], Alan Burrill |
Next by Thread: | Re: Re: Taps [was: Drills], Europa |
Indexes: | [Date] [Thread] [Top] [All Lists] |