Re: Torque Tube Mod?

[Rolph Muller <rolph@globalvt.demon.co.uk>]

In message <199801261628_MC2-30B9-6CF9@compuserve.com>, Graham Singleton
<100421.2123@compuserve.com> writes
>Only deviation we made was to cut two 3"
>holes in the seat back instead of the bottom of the fuselage. Less hassle
>refinishing, better visiblity and you can get two hands into the bowels
>through the seat back and the spar holes.
Thing is tho that issue 2 of the mod instructions does it without
cutting any holes - main difference seems to be that the push rods in
issue 2 are disconnected at the control columns. Now I know that
clearances on my setup are small due the to rivets on the tubes - the
controls work just fine but I really don't want to disturb the set up
more than I need to - so mod version1, mod version 2 or mod version
Graham S. I quite fancy the latter this morning - so where did you cut
the holes Graham - or will that become obvious? Does this approach also
get rid of the need to remove the CS09 brackets by any chance?
-- 
Rolph Muller