Figure 6 in chapter 17 which shows the installation of the rudder cable
pulley is somewhat optimistic about the size of the hard point actually
installed. If one scales the drawing up based on the size of the pulley one
would expect the forward end of the hard point to be 8.4cm from the rear
vertical face; the measured value on my kit is 7.4cm.
In marking out the positions for the pulley and seat belt holes per the
drawing I found that the seat belt bolt would be under the pulley rather than
clear of the pulley as shown in the drawing.
Since spacers will be added under the pulley, it is not clear whether the
pulley will interfere with the end of the bolt if it is drilled per
instructions. Some guidance here would be appreciated.
Regards,
John Moran, A044
|