Wondered about this at the time. It's actually rather difficult to see whether
the perspex is seating well all the way round the door on a trial fit - it's
very obvious when you apply the Redux though - trouble is you may well find you
need extra pressure to get it seating well and of course as you apply more
pressure, the edge of the perspex moves outwards towards the edge of the seating
area - and if you havn't left enough gap you have to do what I had to do on one
of them - pull it out, clean it up, file it down and start again. Sod of a job,
but there you go.
Regards,
Rolph
|