Thank you
Much appreciated.
William Daniell
+1 786 878 0246
On Thu, May 5, 2022, 22:27 h&jeuropa <butcher43@att.net> wrote:
>
> Will,
>
> We replaced the original factory door seals with ones from McMaster Carr.
> Here is a link to the page: https://www.mcmaster.com/catalog/128/3850
>
> The one we use is PN 12335A44.
>
> Our doors fit perfectly when we built the plane until we installed the
> factor door seal. Then they bowed. We were told to just let the doors be
> exposed to outdoor heat and that would correct the bowing. It never did.
> The above seal is better, but the rear of the doors still bow out some.
> But they don't leak rain and they are flush at the front. They haven't
> changed in years.
>
> Jim
>
>
> Read this topic online here:
>
> http://forums.matronics.com/viewtopic.php?p=506677#506677
>
>
|