Hello Ivan
Thanks very much for that, yes I will take it please.
Can you Private message me with your details and your preferred method of
collection?
Cheers
Mike
PS I must say a thank you to all of you that provided help on this subject,
it has been good to hear from you. Matronics has scored again, thanks.
-----Original Message-----
From: owner-europa-list-server@matronics.com
[mailto:owner-europa-list-server@matronics.com] On Behalf Of
ivanshaw@btinternet.com
Sent: 24 November 2020 10:12
Subject: RE: Europa-List: replacement glass
Hi Mike,
I have a new pax door clear canopy in stock. You can have it for 150 which
is less than the shipping cost from LP Aero in the US.
Kindest Regard
Ivan
-----Original Message-----
From: owner-europa-list-server@matronics.com
<owner-europa-list-server@matronics.com> On Behalf Of Monoman
Sent: 23 November 2020 16:51
Subject: Europa-List: replacement glass
Hello All
This spring I managed to break the glass in the passenger side door of my
classic mono, a long story. I got it repaired and although this is
reasonable the crack is still clearly visible and I would like to get rid of
it altogether.
I managed to purchase a couple of used XS doors which of course are tinted
but I think looked a lot better.
However my mono has had the cockpit width mod done and while fitting the new
doors what I thought might be an easy fit has now turned into quite a
difficult amount of work.
I am thinking now that it might be easier just to replace the glass in the
original door?
So to the question, does anyone have just the original classic clear glass
for the passenger side or can direct me to where I might get one?
I am not averse to replacing both sides with XS tinted if clear glass is now
unobtainable, but it would come down to cost.
I have been told that they are only now made new in the States and that
there is a massive lead time in obtaining them, is this true?
I should say that although I have previously built an aircraft, I did not
build my Europa.
Thanks
Mike
G-DURO
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=499479#499479
|