Tony
See my website. I made an oven out of expanded polystyrene. For heat i
used a fan heater with a thermostat set for 40deg c. The whole thing cost
less than usd100.
William Daniell
+1 786 878 0246
On Sun, May 3, 2020, 18:03 Tony Renshaw <tonyrenshaw268@gmail.com> wrote:
>
>
> Gidday,
> It=99s come the time for me to fill and sand my tailplanes. The man
ual
> throws up an immediate impediment to post cure them, wish I=99d tho
ught about
> that over summer because I could have just put them in the roof of my hou
se
> which on a 40 degree day would have easily got to 50+ degrees Celsius, I
> think 50-55 degrees is the goal, if my memory serves me correctly, and ye
s
> I will check. Making an oven just for the tailplanes, does anyone have a
> suggestion of the best way to do this? I have an idea to use structural
> flooring plywood to make up a box and put a blow heater in there, plus
> thermometers and some way to swirl the air around so there are no hotspot
s.
> That=99s not going to be easy to temperature control, so I was hopi
ng
> builders might offer up ways I could do this, without it becoming a pizza
> oven into the future, keeping it simple would be a nice goal, of mine.
> I do recall that the process is important that the temperature be ramped
> up slowly, and cooled down slowly, is that what others think too? Any hel
p
> on ovens gratefully considered.
> Regards
> Tony Renshaw
>
>
===========
===========
===========
===========
===========
>
>
|